Please note that the values shown here, are the basic configuration values of​our tuning article.

TÜV Certificate:   Not available

With the exclusive PowerControl PDI10-Modul up to eight parameters can be changed via various sensors. Additional power is achieved depending on rpm (if necessary) by changing the amount of fuel injected in relation to a change in the boost pressure. The maximumof eight parameters include amount of fuel injected, boost pressure, air mass, rpm, temperature and load conditions.

The PowerControl PDI10-Modul consists of high-tech electronics and is well protected by a special, heat and acid-resistant plastic. Completely waterproof!

The Cable Harness is equipped with a maximum of ten connections and is checked electronically several times before shipment. The sturdy 18-pin connector from the automotive sector is specially designed for tough conditions. The adapter plugs are manufactured in OEM quality. No soldering or cutting any wires is necessary. Just connect it up and it's done!

The PDI10 System is subject to the strict quality controls at DTE-Systems GmbH. This guarantees that you, the customer, will receive a perfect product.

Installation: Using the illustrated installation instructions provided, installation can be done quickly and easily; even if you have no knowledge of electronics, you can do it yourself in no time thanks to the original plug and socket connector. You don't need any special tools, nor to do any soldering or anything similar.  The systems are already set for each type of vehicle and require no further adjustments. Plug it in and it's done!

Without TÜV approved the unaudited operating results of chip tuning in the vehicle to that the general operating of the whole car disappears. A permissible operating by restoring the general operating permit is only through a Individual acceptance by a single demonstration in a competent inspection service § 21 StVZO possible. But this is generally not a problem.